DTC Troubleshooting: 11-4
| DTC 11-4: | Short to Power in Driver's Side Airbag Inflator |
Special Tools Required
SRS inflator simulator( 07SAZ-TB4011A)
Erase the DTC memory.
| 2. | Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.
Does the SRS indicator stay on?
YES - Go to Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures.
|
| 3. | Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.
|
| 4. | Disconnect the SDo connector from the SDi connector (A).  |
| 5. | Connect the special tool (2 W connector) to the SDi connector (A).
|
| 6. | Reconnect the battery negative cable.
|
| 9. | Disconnect the battery negative cable, and wait for 3 minutes.
|
| 10. | Disconnect the TL1o and TR1o connectors (A) from the TL1i and TR1i connectors (B).  |
| 11. | Disconnect the U2o connector (A) from the SRS unit.  |
| 12. | Reconnect the battery negative cable.
|
| 13. | Turn the ignition switch ON (II).
|
| 14. | Disconnect the SRS inflator simulator (special tool) from the SRS simulator lead C.
|
| 15. | Check for voltage between the A terminal of the SRS simulator lead C (special tool) and body ground, and between the B terminal and body ground. There should be 0.5 V or less.  Is the voltage as specified?
YES - Faulty SRS unit; replace the SRS unit.n
NO - Replace the floor wire harness.n |
Honda Fit/Jazz 02-05 Workshop Manual
Back to all Manuals
