DTC Troubleshooting: 3-4
DTC 3-4: | Short to Power in Left Side Seat Belt Tensioner |
Special Tools Required
SRS inflator simulator( 07SAZ-TB4011A)
Erase the DTC memory.
2. | Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.
Does the SRS indicator stay on?
YES - Go to Go to Troubleshooting Intermittent Failures.
|
3. | Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.
|
4. | Disconnect the TL1o connector from the TL1i connector (A). |
5. | Connect the special tool (2 W connector) to the TL1i connector (A). |
6. | Reconnect the battery negative cable.
|
9. | Disconnect the battery negative cable, and wait for 3 minutes.
|
10. | Disconnect the TR1o connector (A) from the TR1i connector (B). |
11. | Disconnect the U2o connector (A) from the SRS unit. |
12. | Disconnect the SRS inflator simulator (special tool) from the SRS simulator lead C.
|
13. | Reconnect the battery negative cable.
|
14. | Turn the ignition switch ON (ll).
|
15. | Check for voltage between the A terminal of the SRS simulator lead C (special tool) and body ground, between the B terminal and body ground, between the C terminal and body ground, and between the D terminal and body ground. There should be 0.5 V or less. Is the voltage as specified?
YES - Faulty SRS unit; replace the SRS unit.n
NO - Short to power in the floor wire harness; replace the floor wire harness.n |
Honda Fit/Jazz 02-05 Workshop Manual
Back to all Manuals