Honda Fit/Jazz - Front Door Outer Handle Replacement (Except KH)
Front Door Outer Handle Replacement
NOTE: Put on gloves to protect your hands.
Plastic cover, as necessary
3. | Without Super Locking: Remove the clip, and release the hook(A) from the latch (B), then remove the lock rod protector (C).
|
4. | With Super Locking: Pull the glass run channel(A) away as necessary,and remove the bolts (B, C), then remove the center lower channel(D).
|
5. | With Super Locking: Remove the screws (A, B), then remove the cylinder switch (C) with the cylinder switch harness bracket (D) from the outer handle protector (E).
|
6. | With Super Locking: Remove the cylinder switch (A).
-1 | Disconnect the cylinder switch connector (B).
| -2 | Release the harness clips (C).
| -3 | Remove the bolts, then remove the harness protector (D) from the door.
| -4 | Pull the switch and harness from inside the door.
|
|
7. | Release the retainer clip (A), then remove the lock cylinder (B). Disconnect the cylinder rod (C).
|
8. | Disconnect the outer handle rod (A), and remove the bolts, then remove the outer handle protector (B) from the outer handle (C).
|
9. | Pull out the outer handle (A) in the numbered sequence, and remove it.
|
10. | Install the handle in the reverse order of removal, and note these items:
- Make sure the cylinder switch harness is routed properly ( for some models).
- Make sure the cylinder switch connector is plugged in properly (for some models), and each rod is connected securely.
- Make sure the door locks and opens properly.
- When installing the lock cylinder, leave the outer door handle bolts loose so the inner protector does not interfere with the lock cylinder, then tighten the handle bolts.
- Install the lock cylinder retaining clip on the handle, then install the lock cylinder. Be sure the clip is fully seated in the slot on the lock cylinder.
|
Honda Fit/Jazz 02-05 Workshop Manual
Back to all Manuals