Engine Removal
Special Tools Required
Engine tilt hanger set( 07KAK-SJ40101)
Remove the steering gearbox from the front subframe.
29. | Disconnect the compressor clutch connector (A), then remove the A/C compressor (B) without disconnecting the A/C hoses.
|
30. | Remove the condenser fan shroud.
|
31. | Remove the automatic transmission fluid (ATF) cooler hoses, then plug the ATF cooler hoses and lines (CVT).
|
33. | Remove the upper radiator hose (A) and lower radiator hose (B).
|
34. | Remove the heater hoses.
|
35. | Attach the engine tilt hanger set to the engine as shown.
|
36. | Remove the ground cable (A), then remove the transmission mount bracket (B).
M/T:
CVT:
|
37. | Remove the ground cable (A), then remove the side engine mount/bracket assembly (B).
M/T:
CVT:
|
38. | Make sure the hoist brackets are positioned properly. Raise the hoist to full height.
|
39. | Remove the rear mount mounting bolts.
|
40. | Remove the left front mount/bracket assembly(M/T).
|
41. | Remove the front subframe .
|
42. | Check that the engine/transmission is completely free of vacuum hoses, fuel and coolant hoses, and electrical wiring.
|
43. | Slowly lower the engine about 150 mm (6 in.). Check once again that all hoses and wires are disconnected from the engine/transmission.
|
44. | Lower the engine all the way. Remove the chain hoist from the engine.
|
45. | Remove the engine from under the vehicle.
|
Honda Fit/Jazz 02-05 Workshop Manual
Back to all Manuals